FMS500 ONE

IP67 Tough protection case against harsh weather conditions. Made from ABS plastic with UV protection. Works in low and high temperatures and certified for IP67 ingress ratio. A build-in breathing valve lets out humidity which appears during temperature change and saves internal components from oxidation. Universal for all FMS500/XG3700 series

OBD extension cables make FMS500/XG3700 series devices installation as easy as possible, just plug and play. No extra tools or wiring required

RFID card is the most simple, common and cheap proximity card for access control systems.

Compact Embed RFID reader is designed for using with Mifare 13.56MHz keys cards.

RFID card is the most simple, common and cheap proximity card for access control systems.

Key fob is affordable proximity RFID key fob for using in access control systems.

Compact Embed RFID reader is designed for using with 125KHz key fobs and 125KHz cards.

iButton key devices are small, durably and easy to care. Magnet which is under the chip lets connect key to reader and it stays there all the time. It lets to make more scenarios for identification.

iButton key devices are small, durably and easy to care. The iButton serial number is a rugged data carrier that serves as an electronic registration number for automatic identification.

The driver is expected to touch the iButton to the reader to start engine or identify himself. Reader can shine in RGB colors, LED is inside.

Magnetic Sensor adopts hall effect when the magnetic buttons go through the front end of the Magnetic Sensor, and thus causing the magnetic field changes.

Mechanical or magentic sensors are used to identify vehicle door open/close operations.

A load cell (or loadcell) is a transducer which converts force into a measurable electrical output.

Axle load sensor is designed for axle load control and cargo weight control in vehicle tracking systems.

Card reader device with USB interface which connects to PC server. It can read Company Card where BCE tacho application is installed.

Driver identification consists of 2 devices Key fob or card and Reader. Each driver has Key fob or card with unique id number. Once Key fob or card is swiped to reader, signal is send to GPS tracking device.

By integrating panic buttons with vehicle tracking, it is possible to receive an immediate notification that a device has been activated.

Driver identification consists of 2 devices Key and Reader. Each driver has iButton key with unique id number. Once key is connected to reader, signal is send to GPS tracking device. Identification ensures that a particular vehicle is driven by the designated driver himself.

It is a low cost temperature sensor with a 1-wire digital interface. The sensor is calibrated and doesn’t require extra components so you can get right to measuring relative temperature.

Fuel Level Sensor is installed into a fuel tank of a vehicle. The sensor measures fuel level in the tank and generates an output signal to forward it to a vehicle tracking device.

Fuel meter enables to receive objective information about actual fuel consumption and vehicle working time.

S-CAN is a contactless CAN-bus reader, allowing to retrieve data from various type vehicles without physical contact with vehicle wires, thus eliminating warranty issues.

12V and 24V relays are used for making remote engine block circuit.